OBD2 USB Interface for BMW INPA, ISTA+ and MHD FlasherīMW INPA cable runs with BMW’s factory INPA ( EDIABUS/ DIS/ PROGMAN/ SSS/ NCSExpert) and ISTA+ diagnostics software as well as third-party software like MHD Flasher. This cable is intended for use with E-Series BMW’s only, for F-/G-Series cars, have a look at the BMW Ethernet Cable instead.Ĭable length is about 28cm not including the connectors on either end Start the AK 95 S with the main switch and the ON/OFF. Note The complete calibration will not run (but nothing will get destroyed) if the cable is reversed. Modification cable INPA pour BMW - YouTube 0:00 / 4:54 Modification cable INPA pour BMW 511 views 35 Dislike Share Save DébrouilleToi 11. BOX should be connected to the UF calibration box. The part of the cable that is labeled UF. Open the Ports tab (COM and LTP) Select USB Serial port (COM3) go to properties, advanced parameters and change COM3 to COM1 and response time (ms) to 1. Next, we need to configure our INPA K+DCAN cable, go to the device manager. The BMW INPA D+KCAN USB Cable is often bought with the BMW 20 pin to 16 pin OBD2 adaptor. Buy For BMW INPA K DCAN USB Interface With Switch K-line OBD OBD2 Diagnostic Cable INPA K+DCAN K line FTDI for BMW Auto Tool at Wish - Shopping Made Fun. Use the UF calibration cable, K1 4036, to connect the AK 95 S with the UF calibration box. Place the BMW icon from the BimmerGeeks Standard Tools folder on your desktop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |